Read moreShow less
Various spare parts for the wireless Chill SP-1 Bluetooth speaker (also proven compatible with some similar X05 versions from other makers. However we have no knowledge of these, so please compare carefully before buying).
The Chill SP-1 speaker has been made in several versions / revisions over the years, which is why various components have been used. These spare parts are, as a rule, only for the latest Chill SP-1 BT Speaker version (V2017) and will therefore typically not be compatible with older/other versions. Compare the spare part of the picture with the one your speaker is currently using before purchasing.
The most common errors are related to charging:
If you can no longer obtain a charging contact, this is typically because the Micro-USB connector in the speaker has been damaged.
The latest SP-1 edition have a separate USB print on the backside. However, these have also been produced in multiple versions, so you have to compare the speaker backside / USB print thoroughly with the pictures here. The speaker will need to be completely disassembled to get into the USB print on the back, which is relatively extensive work.
Older SP-1 speaker versions might have the Micro-USB port at the top along with the main buttons itself (PCBA), so this is not profitable to replace. Here, a new standard Micro-USB port can usually be soldered on instead.
IMPORTANT! - It requires technical / professional expertise to carry out repair work. This is not recommended to perform for private individuals etc. Spare parts are tested before shipment and all repairs/replacements are done at your own risk! The front with the fabric on is typically partially glued, but can be gently twisted free with e.g. a wide dining knife / flat screwdriver on both sides - and then pulled off the rails.